Ultrazone 360
Installation Instructions

Used WITHOUT redox controller

1) Connect the airline from an air supply or venturi 
to the connection on the top of the unit.
2) Connect the airline, going to the skimmer or reactor,
to the connection on the back of the unit
3) Move switch on the top of the unit to the 'HI'
position.
4) Plug the power cord into a GFCI protected, grounded 
receptacle.
5) Adjust airflow through the unit to meet your needs.

Used WITH a redox controller

1) Follow above instructions steps 1-3
2) Plug the power cord into your redox controller.

NOTE - The external hosing shuold be examined periodically.
It is normal for these hoses to require replacement.
This is a non-warranty item and can be purchased
as needed.

The ozone producing bulb is mounted externally on the 
rear of the ozone generator. If the ozone bulb requires
replacement (when the bulb fails to produce light) simply
remove the 2 air line connections, remove white endcap, 
disconnect the electrical connection, unclip the 2 cartridge
retaining clamps, remove bulb retaining nut and gasket.
You can now slide the ozone bulb out of the stainless 
steel housing an install new ozone bulb in reverse order.