INSTRUCTIONS FOR INSTALLING REVERSE OSMOSIS AUTO SHUT-OFF
 
PARTS INCLUDED: FLOAT VALVE ASSEMBLY, AUTO SHUT-OFF MODULE,
                8 FT. 1/4" PRESSURE HOSING
 
   
1.  INSTALL HOSING FROM THE OUTPUT SIDE OF THE CARBON FILTER      
    HOUSING TO "IN" CONNECTION (#1 ON DIAGRAM) ON THE SHUT-OFF    
    MODULE.
2.  INSTALL HOSING FROM "OUT" (#2 ON DIAGRAM) CONNECTION ON SHUT- 
    OFF MODULE TO THE INPUT SIDE OF THE REVERSE OSMOSIS MEMBRANE. 
    (SINGLE FITTING AT END OF THE MEMBRANE)
3.  (FOR MODELS URP25, URP50, URP100) 
    INSTALL THE BLUE HOSING (PURE WATER LINE), THAT COMES FROM THE 
    END OF THE REVERSE OSMOSIS MEMBRANE WERE THERE ARE 2 FITTINGS. 
    TO THE CONNECTION BELOW "OUT" (#3 ON DIAGRAM) CONNECTION ON   
    SHUT-OFF MODULE.
    (FOR MODELS POL25, POL50, POL100)
    INSTALL THE BLUE HOSING (PURE WATER LINE), THAT COMES FROM THE 
    OUTPUT OF THE DEIONZING CHAMBER TO THE CONNECTION BELOW THE   
    "OUT" (#3 ON DIAGRAM) CONNECTION ON THE SHUT-OFF MODULE.
4.  INSTALL THE FLOAT VALVE INTO AN OPEN-AIR STORAGE TANK, THEN   
    ATTACH THE HOSING BETWEEN THE FLOAT VALVE AND TO THE CONNECTION 
    BELOW THE "IN" (#4 ON DIAGRAM) CONNECTION ON SHUT-OFF
    MODULE.
5.  INSTALL THE CHECK VALVE (1/8" COMPRESSION ELBOW) INTO THE 
    "PURE WATER" OUTPUT FROM THE R.O. MEMBRANE HOUSING (END OF    
    REVERSE OSMOSIS MEMBRANE WERE THERE ARE 2 FITTINGS. (YOU
    NEED TO REMOVE THE EXISTING ELBOW FITTING FIRST).
 
 
                      ------------------------
                2.   |  OUT            IN     |  1.  
                     |                        |                  
                     |                        |
                3.   |                        |  4.              
                     |                        |
                      ------------------------
                         WHITE SHUT-OFF MODULE