Ultrazone MINI
Installation Instructions

Used WITHOUT redox controller

1) Connect the airline from an air supply or venturi 
to the connection on the back of the ozone bulb chamber
labeled "IN".
2) Connect the airline, going to the skimmer or reactor,
to the connection on the back of the bulb chamber that
has no markings.
3) Plug the power cord into a GFCI protected, grounded 
receptacle.
4) Adjust airflow through the unit to meet your needs.

Used WITH a redox controller

1) Follow above instructions steps 1-3
2) Plug the power cord into your redox controller.

CAUTION -- AIRFLOW MUST BE IN THE PROPER DIRECTION TO
AVOID SERIOUS DAMAGE TO THE OZONE BULB CHAMBER. IF THE
UNIT IS INSTALLED IMPROPERLY AND DAMAGE OCCURS, THE 
WARRANTY WILL BE VOID.

The ozone producing bulb is mounted externally on the 
rear of the ozone generator. If the ozone bulb requires
replacement (when the bulb fails to produce light) simply
remove the 2 air line connections, remove white endcap, 
disconnect the electrical connection, unclip the 2 cartridge
retaining clamps, remove bulb retaining nut and gasket.
You can now slide the ozone bulb out of the stainless 
steel housing an install new ozone bulb in reverse order.