3-PIECE END CAP INSTALLATION
                                
     STRIP OFF THE PLASTIC INSULATION FROM THE END OF EACH WIRE
TO EXPOSE APPROXIMATELY 3/8" OF BARE WIRE. INSERT APPROPRIATE
WIRE INTO SMALL OPENINGS ON OUTER BOTTOM EDGE OF END CAP. AFTER
WIRES ARE INSERTED AND WILL NOT PULL BACK OUT, APPLY SILICONE OR
WATER PROOF SEALANT AROUND WIRE. ALLOW SEALANT TO DRY ACCORDING
TO MANUFACTURERS INSTRUCTIONS. THE END CAPS CAN BE MOUNTED INTO
CANOPY BY USING TWO M4 METRIC THREAD SCREWS. THE LENGTH OF THESE
SCREWS SHOULD BE LONG ENOUGH TO GO THROUGH YOUR CANOPY. INSTALL
THE BLACK RUBBER GASKET BETWEEN THE END CAP AND YOUR CANOPY TO
PROVIDE A SEAL.